Match Ip Route-Source - Dell S4810 Reference Manual

match route-type
match tag

match ip route-source

To match based on the routes advertised by routes specified in IP access lists or IP prefix lists, configure a
filter.
S4810
Syntax
match ip route-source {prefix-list prefix-list-name}
To delete a match, use the no match ip route-source {prefix-list
prefix-list-name} command.
Parameters
prefix-list
prefix-list-
name
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
match interface
Commands
match ip address
278
— redistributes routes that match a route type.
— redistributes routes that match a specific tag.
Enter the keywords prefix-list and then enter the name
of configured prefix list, up to 140 characters.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match the next-hop interface.
— redistributes routes that match an IP address.
Access Control Lists (ACL)