Ipv6 Pim Spt-Threshold - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

ipv6 pim spt-threshold

[ no ] ipv6 pim spt-threshold { 0 | nonZeroInteger | infinity }
Syntax
[ group-list ipv6AccessList ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the network configuration that PIM sparse mode uses when a source starts
Description
sending multicast messages. The no version restores the default value, 0.
Options
Global Configuration
Mode
1082
ipv6 pim spt-threshold
0 Configures PIM sparse mode to switch to an SPT when a source begins to
send multicast messages
nonZeroInteger—Integer in the range 1–4294967294; prevents PIM sparse mode
from switching from a shared tree to an SPT
infinity Prevents PIM sparse mode from switching from a shared tree to an
SPT
ipv6AccessList—Name of the IPv6 access list that specifies the groups to which
the threshold applies