ABB CRB 15000 Product Manual page 465

3
Refitting the flanges
Use these procedures to refit the tool flange and axis-6 inner flange.
Refitting the tool flange adapter
1
2
Product manual - CRB 15000
3HAC077389-001 Revision: E
5.4.5 Replacing the tool flange and axis-6 inner flange
Action
Remove the tool flange adapter.
Action
Clean the mounting surface with isopropanol.
Apply flange sealant to the corner of the adapter
mounting surface, as pointed out in the figure.
Refit the tool flange adapter, aligning the pin with
the pin hole.
© Copyright 20212022 ABB. All rights reserved.
5 Repair
Continued
Note
xx2000002167
Note
Cleaning agent: Isopropanol
Flange sealant: Loctite 574
xx2000002196
Axis-6 inner flange: 3HAC073952-
001
xx2000002167
Continues on next page
465