ABB CRB 15000 Product Manual page 658

5 Repair
5.6.5 Replacing the axis-5 joint unit and the axis-5 to axis-6 transition cabling
Continued
2
3
4
Continues on next page
658
Action
CAUTION
There is cabling connected between the cover
and the joint unit drive board.
Open the cover with care to avoid damage to the
cabling or the connector(s).
Do not leave the cover in location without being
secured with the attachment screws.
Open the cover and cut the cable tie that holds
the brake release cable.
Disconnect the brake release connector DR.X8
from the drive board.
Remove the cover.
© Copyright 20212022 ABB. All rights reserved.
Note
xx2000002084
Tweezers
xx2000002085
Product manual - CRB 15000
3HAC077389-001 Revision: E