ABB CRB 15000 Product Manual page 321

Hide thumbs Also See for CRB 15000:

Table of Contents

Removing the arm-side interface

Product manual - CRB 15000

3HAC077389-001 Revision: E

Remove the tool flange adapter.

Make sure that all supplies for electrical power

are turned off.

There is cabling connected between the arm-side

interface and the joint unit drive board.

Open the arm-side interface with care to avoid

damage to the cabling or the connector(s).

Do not leave the arm-side interface in location

without being secured with the attachment screws.

Remove the attachment screws.

Loosen the arm-side interface carefully and dis-

connect the connectors from it.

5.3.7 Replacing the axis-6 cabling

xx2000002167

xx2000002550

xx2100000335

Continues on next page

Troubleshooting