ABB CRB 15000 Product Manual page 160

5 Repair
5.3.2 Replacing the axis-1 cabling
Continued
Spare part
Cable harness, joint 1
Flange socket head screw with
glue
Cable tie
Required tools and equipment
Equipment
Lifting aid
Guide pin, M4x120
Protection plate
Cable tie gun EVO7
Standard toolkit
Required consumables
Consumable
Cable ties
O-ring, nitrile rubber
O-ring
O-ring
Grease
Cleaning agent
Flange sealant
Continues on next page
160
Article number
3HAC073204-001
3HAB3413-435
3HAC075545-001
Article number
3HAC077788-001
3HAC077786-001
3HAC077790-001
-
-
Article number
-
3HAB3772-64
3HAC061327-044
3HAC061327-047
3HAC042536-001
-
-
© Copyright 20212022 ABB. All rights reserved.
Note
Also order new Cable tie:
3HAC075545-001.
M4x35 12.9 Lafre
2C2B/FC6.9+PrO-COat111, with
NYPLAS glue , 12 pcs
Always use new screws when re-
fitting a joint unit. If ordering a
new joint unit spare part, new
screws are included.
For securing joint unit cable.
Note
For joint units on axes 1, 2 and 3.
Attachment screws M4x35 (4 pcs)
are enclosed.
Always use guide pins in pairs.
For joint units on axes 1, 2 and 3.
For protection of drive board
during cabling installation on joint
unit.
HellermannTyton 110-70084 or
similar
Content is defined in section
Standard toolkit on page 749.
Note
Base cover
Lower arm, inner cover. 1 pcs /
cover.
Replace if damaged.
Cover for axis 2/3
Replace if damaged.
Shell Gadus S2
Isopropanol
Loctite 574
Product manual - CRB 15000
3HAC077389-001 Revision: E