Honda Accord 2008 Manual page 307

07/11/02 09:13:50 61TA0000_100_0012
Cooling System
Water Passage Replacement (cont'd)
21. Install the intake manifold (see page 9-5).
22. Install the drive belt auto-tensioner (see page 4-33).
23. Install the alternator (see page 4-34).
24. Install the A/C compressor (see step 42 on page
5-19).
25. Install the splash shield (see step 48 on page 5-20).
26. Check the quick connector (A) and set ring (B) for
cracks or damage. If the connector and/or set ring
are cracked or damaged, replace the connector.
＊０８
27. Make sure the set ring is in place inside the quick
connector. If the set ring is off the connector,
replace the quick connector.
28. Replace a new O-ring (C) in the quick connector.
29. Check the lock (D). If the lock is damaged or
deformed, replace it. When installing the new lock
on the connector, push it straight down along the
groove.
30. Clean the connecting surface of the thermostat
cover (E), then apply clean engine coolant around
the connecting surface.
10-12
B
D
E
A
31. Push the lock (A) down, then push the quick
connector (B) onto the thermostat cover until you
hear it click.
C
Replace.
32. Refill the radiator with engine coolant, and bleed
air from the cooling system with the heater valve
open (see step 6 on page 10-6).
B
A
＊０９