Water Outlet Removal And Installation - Honda Accord 2008 Manual

07/11/02 09:13:51 61TA0000_100_0013

Water Outlet Removal and Installation

1. Drain the engine coolant (see page 10-6).
2. Remove the breather pipe (A), then remove the
intake air duct (B).
NOTE: When torquing the screw of the hose band
(C), align the edge of the hose band (D) with the
mark (E) painted on the hose band. If you tighten
the screw over the mark, replace the hose band.
＊０１
B
A
3. Remove the upper radiator hose (A), the heater
hose (B), and the water bypass hose (C).
＊０２
C
C
D
E
B
A
4. Remove the intake manifold (see page 9-3).
5. Remove the connecting pipe mounting bolts (A),
then remove the connecting pipe (B).
A
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
B
Replace.
6. Disconnect the engine coolant temperature (ECT)
sensor 2 connector (A), then remove the water
outlet (B).
C
Replace.
B
7. Install the water outlet with a new gasket (C).
8. Install the other parts in the reverse order of
removal.
9. Refill the radiator with engine coolant, and bleed
air from the cooling system with the heater valve
open (see step 6 on page 10-6).
ＴＡ０８ＡＥ４Ａ１４４０００６５０８１ＫＤＡＴ００
A
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
16 lbf·ft)
10-13
＊０３
＊０４