Oil Jet Replacement; Oil Jet Inspection - Honda Accord 2008 Manual

07/11/02 09:11:22 61TA0000_080_0014
Engine Lubrication

Oil Jet Replacement

1. Remove the oil pump (see page 8-16).
2. Remove the baffle plate (see step 8 on page 7-15).
3. Remove the oil jet bolts (A), then remove the oil jets
(B).
＊０１
4. Carefully install the oil jets, and tighten the oil jet
bolts.
5. Install the baffle plate (see step 24 on page 7-30).
6. Install the oil pump (see page 8-22).
8-14 8-14
ＴＡ０８ＡＥ４Ａ３２２０００４３３５１ＫＢＡＴ０１
A
8 x 0.75 mm
16 N·m
B
(1.6 kgf·m, 12 lbf·ft)

Oil Jet Inspection

1. Remove the oil jet (see page 8-14), and inspect it as
follows.
• Make sure that a 1.2 mm (0.05 in.) diameter drill
will go through the nozzle hole (A) (1.31 mm
(0.052 in.) diameter).
• Insert the other end of a 3.7 mm (0.15 in.) drill
into the oil intake (3.8 mm (0.15 in.) diameter).
Make sure the check ball (B) moves smoothly and
has a stroke of about 2.0 mm (0.08 in.).
• Check the oil jet operation with an air nozzle. It
should take at least 380 kPa (3.9 kgf/cm , 55 psi)
to unseat the check ball.
NOTE: Replace the oil jet assembly, if the nozzle is
damaged or bent.
A
B
2. Carefully install the oil jet. The mounting torque is
critical.
Specified Torque: 16 N·m (1.6 kgf·m, 12 lbf·ft)
ＴＡ０８ＡＥ４Ａ３２２０００４３３５１ＭＡＡＴ０２
2
1.31 mm (0.052 in.)
＊０１