Oil Pump Chain Replacement - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:11:42 61TA0000_080_0024

Engine Lubrication

Oil Pump Chain Replacement

NOTE: Keep the oil pump chain away from magnetic

1. Remove the drive belt (see page 4-31).

2. Remove the oil pan (see page 7-12).

3. Support the engine with a jack and a wood block

under the edge of the engine block.

NOTE: Do not hit the oil strainer when placing the

jack on the edge of the engine block.

4. Remove the cam chain:

• All models except PZEV (see page 6-13)

• PZEV model (see page 6-64)

5. Loosely install the crankshaft pulley.

6. To hold the rear balancer shaft, insert a 6 mm long

pin punch (A) (Snap-on PPC108LA or equivalent)

into the maintenance hole in the balancer shaft

holder and through the rear balancer shaft.

7. Turn the crankshaft counterclockwise to compress

the oil pump chain auto-tensioner.

8. Remove the crankshaft pulley.

9. Align the holes on the lock (A) and the oil pump

10. Loosen the oil pump sprocket mounting bolt (A).

ＴＡ０８ＡＥ４Ａ３２２０００４３５１３ＫＢＡＴ００

chain auto-tensioner (B), then insert a 3.0 mm

(0.1 in.) diameter pin (C) into the holes. Turn the

crankshaft clockwise to secure the pin.

NOTE: Check the oil pump chain auto-tensioner

cam position is not aligned, set the first cam to the

first edge of the rock.

Table of Contents