Honda Accord 2008 Manual page 282

07/11/02 09:11:40 61TA0000_080_0021
11. Remove the upper balancer shaft holder and the
bearings again, and measure the widest part with
the plastigage. If balancer shaft No. 3 journal oil
clearance is out-of-tolerance, install new bearings,
and recheck. If it is still out-of-tolerance, replace the
balancer shafts.
No. 3 Journal Oil Clearance
Standard (New): 0.060 0.120 mm
Service Limit:
＊２０
12. Align the punch mark on the rear balancer shaft in
the center of the two punch marks on the front
balancer shaft, then install the balancer shafts on
the lower balancer shaft holder.
＊２１
−
−
(0.0024 0.0047 in.)
0.15 mm (0.006 in.)
13. Apply new engine oil to the threads of the 8 mm
bolts (A).
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
14. Install the upper balancer shaft holder (B) with a
new O-ring (C).
15. Install the pump housing.
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
＊２２
A
8 x 1.25 mm
27 N·m
(2.8 kgf·m,
20 lbf·ft)
C
Replace.
B
＊２３
(cont'd)
8-21