Honda Accord 2008 Manual page 281

Hide thumbs Also See for Accord 2008:
Table of Contents

Advertisement

07/11/02 09:11:26 61TA0000_080_0020
Engine Lubrication
Oil Pump Overhaul (cont'd)
7. Measure the diameters of the No. 2 journals on the
front balancer shaft and the rear balancer shaft.
Journal Diameter
Front:
Standard (New): 19.938 19.950 mm
Service Limit:
Rear:
Standard (New): 23.938 23.950 mm
Service Limit:
Front
*17
Rear
*18
8-20
(0.7850 0.7854 in.)
19.92 mm (0.784 in.)
(0.9424 0.9429 in.)
23.92 mm (0.942 in.)
8. Clean both balancer shaft No. 3 journals and the
bearing halves with a clean shop towel, then place
both balancer shafts into the balancer holder.
9. Place one strip of plastigage across each No. 3
journal.
10. Reinstall the bearings and the upper balancer shaft
holder, then tighten the bolts.
NOTE: Do not rotate the balancer shafts during
inspection.
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
*19
8 x 1.25 mm
27 N·m
(2.8 kgf·m,
20 lbf·ft)

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents