Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\LLDP.fm
lldp tx-delay
Use the lldp tx-delay Global Configuration mode command to set the delay
between successive LLDP frame transmissions initiated by value/status
changes in the LLDP local systems MIB. Use the no form of this command to
restore the default configuration.
Syntax
seconds
lldp tx-delay
no lldp tx-delay
Parameters
seconds—Specifies the delay in seconds between successive LLDP frame
transmissions initiated by value/status changes in the LLDP local systems
MIB. (Range: 1?8192 seconds)
Default Configuration
The default LLDP frame transmission delay is 2 seconds.
Command Mode
Global Configuration mode
User Guidelines
It is recommended that the tx-delay be less than 0.25 of the LLDP timer
interval.
Example
The following example sets the LLDP transmission delay to 10 seconds.
Console(config)#
10
lldp tx-delay
lldp optional-tlv
Use the lldp optional-tlv Interface Configuration (Ethernet) mode
command to specify which optional TLVs from the basic set are transmitted.
Use the no form of this command to restore the default configuration.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
428
LLDP Commands
Advertisement
Table of Contents
