ENGINE / COOLING / HVAC SYSTEM
28. Torque oil cooler retaining bolts to specification.
TORQUE
Oil Cooler Retaining Bolts:
7 lb-ft (10 Nm)
29. Proceed to "Flywheel Installation" and then "Cylinder
Head Installation".
STARTER ONE-WAY CLUTCH ASSEMBLY
1. Install one-way clutch in clutch hub with flange of
clutch (F) engaged in recess.
2. Clean screw threads in flywheel to remove all oil or
grease.
3. Place one-way clutch on flywheel and install three
NEW screws. Torque screws to specification.
IMPORTANT
One-Way Clutch Retaining Screws are one time use.
NEW screws must be used when installing the one-way
TORQUE
One-Way Clutch Retaining Screws:
9 lb-ft (12 Nm)
3.78
clutch.
4. Reassemble starter one-way clutch and gear using
the following illustration.
5. If starter gear was replaced, inspect the torque limit
gear.
6. After assembly, be sure the starter gear rotates in the
clockwise direction only.
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
© Copyright Polaris Industries Inc.