Starter One-Way Clutch Assembly - Polaris RANGER XP 900 2013 Manual

3. Remove the one-way clutch and inspect both sides
q
of drive rollers . Inspect the roller contact surface
w
inside the hub for wear, damage or uneven
surface.
4. Inspect drive surface of starter gear
r
for wear, damage or uneven surface. If any starter
one-way clutch component is worn or damaged,
replace the clutch and starter gear as an assembly.

STARTER ONE-WAY CLUTCH ASSEMBLY

1. Install one-way clutch in clutch hub with flange of
q
clutch engaged in recess.
9924880 Rev 2- 1/10/2014 - 2013 / 2014 RANGER XP 900 - 2014 RANGER XP 900 / CREW 900 Service Manual
© Copyright Polaris Sales Inc.
2. Clean screw threads in flywheel to remove all oil or
grease.
3. Place one-way clutch on flywheel and install the
three screws. Torque screws to specification.
4. Reassemble starter one-way clutch and gear using
the following illustration.
e
and bushing
w
Torque Limit Gear
Pin
e
Starter Gear
r
Screws
t
Bolt
5. If starter gear was replaced, inspect the torque limit
gear.
TORQUE
One-Way Clutch Retaining Screws:
106 in-lbs (12 Nm)
y
Flywheel
u
One-Way Clutch
Asm
i
Torque Limit Gear
Asm
ENGINE
3
3.49