Table 179: Chassis Status Leds In The Qfx3600 And Qfx3600-I Device - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation

Table 179: Chassis Status LEDs in the QFX3600 and QFX3600-I Device

Name Color State
Power Green On steadily
Amber Blinking
Status Green On steadily
Intermittent
blinking
Amber Blinking
Fan Green On steadily
Amber Blinking
Related
Documentation
Management Port LEDs in the QFX3600 and QFX3600-I Device
750
Description
The device is powered on.
A temperature or voltage error has been detected, and the device has shut down.
Power off the QFX3600 or QFX3600-I device following the instructions in Powering
Off a QFX3600 Device. Correct any site temperature issues, and allow the device
to cool down. Power on the QFX3600 or QFX3600-I device and monitor the power
supply and fan LEDs to help determine where the error is occurring. If the amber
Power LED begins blinking again, power off the QFX3600 or QFX3600-I device
and contact customer support. See
Return Materials Authorization for a QFX Series Device or Component" on page
Junos OS has been loaded on the device.
The beacon feature has been enabled on the device using the
command.
beacon
A software error has occurred. Power off the QFX3600 or QFX3600-I device by
following the instructions in Powering Off a QFX3600 Device. Power on the
QFX3600 or QFX3600-I device and monitor the management board LEDs to
ensure that Junos OS boots properly.
The fan trays are operating normally.
An error has been detected in a fan tray installed on the rear panel of the device.
Replace the fan tray as soon as possible. To maintain proper airflow through the
chassis leave the fan tray installed in the chassis, until you are ready to replace it.
Front Panel of a QFX3600 Device on page 104
Front Panel of a QFX3600-I Interconnect Device
Rear Panel of QFX3600 and QFX3600-I Devices on page 106
Chassis Alarm Messages on a QFX3500 Device on page 905
The RJ-45 management ports labeled
and in a QFX3600 or QFX3600-I device have two LEDs that indicate link speed
C0S C1S
and activity.
NOTE: On the SFP management ports,
speed.
"Contacting Customer Support to Obtain a
and and SFP management ports labeled
C0 C1
denotes activity, and
LA
Copyright © 2018, Juniper Networks, Inc.
895.
request chassis
denotes
ST