Table 146: Qfx3600 Node Device-To-Virtual Chassis Control Plane Port - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

QFX3000-G QFabric System Hardware Documentation

Table 146: QFX3600 Node Device-to-Virtual Chassis Control Plane Port Assignments

Documentation

To connect a QFX3600 Node device to the QFX3000-G QFabric system control plane

network (see

Figure 220 on page

Connect one end of the first RJ-45 patch cable to the first management port (labeled

) on the Node device front panel.

Connect the other end of that cable to the appropriate member and port on the Virtual

Chassis. See

Table 146 on page

Connect one end of the second RJ-45 patch cable to the second management port

) on the Node device front panel.

Connect the other end of that cable to the appropriate member and port on the second

Virtual Chassis. This should be the same member number and port number that you

connected to in Step 2. For example, if you connected the first cable to

on the first Virtual Chassis, you connect the second cable to

on the second Virtual Chassis.

Repeat this procedure for each Node device.

Connecting QFX3100 Director Devices to a Copper-Based QFX3000-G QFabric System

Control Plane Network on page 502

Connecting QFX3100 Director Devices in a Director Group on page 500

Connecting a QFX3008-I Interconnect Device to a Copper-Based QFX3000-G QFabric

System Control Plane Network on page 505

Connecting a QFX3600 Node Device to a QFX3008-I Interconnect Device on page 547

Connecting a QFX3500 Node Device to a Copper-Based QFX3000-G QFabric System

Control Plane Network on page 515

Connecting a QFX3500 Node Device to a QFX3008-I Interconnect Device on page 548

Chapters

Table of Contents