Juniper QFabric QFX3000-G Hardware Documentation page 689

Copyright © 2018, Juniper Networks, Inc.
Discover the device connection status and the alias name (identifier) by issuing the
2.
show fabric administration inventory interconnect-devices
root@qfabric> show fabric administration inventory interconnect-devices
Item
Interconnect device
IC-QFX3713490033
QFX3713490033/RE0
IC-QFXB3714010454
QFX3714010454/RE0
root@qfabric>
The card must show as
Issue the
request fabric administration power-off interconnect-device serial-id
3.
|alias-name fpc slot operational mode command from the QFabric default partition
CLI. This command systematically takes the node offline and gracefully shuts down
the device while preserving system state information. Use the name of the Interconnect
device in which the rear card you want to remove is installed, and the number of the
slot from which you are removing the rear card; the slots are numbered from
15 . See "Slot Numbering for a QFX3008-I Interconnect Device" on page
You see output similar to the following after entering the command:
root@qfabric> request fabric administration power-off interconnect-device
IC-A0004 fpc 13
STEP 1 of 6 (Acquiring lock):
Acquiring lock to perform this operation
Acquired lock to perform this operation
STEP 2 of 6 (Performing pre-checks):
interconnect-device IC-A0004 is online
STEP 3 of 6 (Gracefully offlining the interconnect linecard):
Gracefully offlining the fpc
fpc is successfully offlined
STEP 4 of 6 (Waiting for convergence):
Waiting for convergence(this will take few minutes)
request fabric administration power-off interconnect-device IC-A0004
Convergence complete
STEP 5 of 6 (Powering-off the interconnect linecard):
Now, powering-off the fpc on the interconnect-device
Powered-off the fpc on the interconnect-device
STEP 6 of 6 (Releasing lock):
Releasing the lock
root@qfabric>
CAUTION: The final output of the
interconnect-devices serial-id |alias-name fpc slot
following message:
the LCDs are off
before following the instructions in
QFX3008-I Interconnect Device" on page
Chapter 41: Replacing QFX3008-I Components
Identifier
and in order to have an orderly shutdown.
connected configured
request fabric administration power-off
The device is shutting down and can be removed when
. Wait at least 3 to 4 minutes after first seeing this message
"Removing a Rear Card from a
command.
Connection Configuration
Connected Configured
Connected
Connected Configured
Connected
through
8
44.
CLI command is the
640.
639