Juniper QFabric QFX3000-G Hardware Documentation page 470

QFX3000-G QFabric System Hardware Documentation
420
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the chassis.
Ensure that the power cords are not connected to power outlets. Switch off the
2.
customer site circuit breakers. Ensure that the voltage across the AC power source is
0 V and that there is no chance that the voltage might become active during
installation.
If the wiring tray is installed in the chassis, remove it. See
3.
from a QFX3008-I Interconnect Device" on page
to the wiring tray as described in
on page 413.
Ensure that the power switch on the wiring tray faceplate is in the OFF (O) position.
4.
Using a number 1 Phillips (+) screwdriver, loosen the four screws on the metal AC
5.
wiring compartment on the side of the wiring tray (see
Open the metal door of the wiring tray compartment.
6.
"Removing a Wiring Tray
608. The power cord must be attached
"Preparing Delta and Wye Three-Phase Power Cords"
Figure 165 on page
Copyright © 2018, Juniper Networks, Inc.
421).