Juniper QFabric QFX3000-G Hardware Documentation page 500

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
Connecting a QFX Series Device to a Management Console
450
NOTE: The switch powers on as soon as power is provided to the power
supply. There is no power switch on the device.
Verify that the IN and OUT
10.
CAUTION: A system reboot with Routing Engine FPGA version 7.1 might
not successfully boot the Junos OS software. In case of a system reboot
failure, you need to power cycle the switch. To check the current FPGA
version, issue the
DC Power Supply in a QFX5100 Device on page 96
DC Power Supply LEDs on a QFX5100 Device on page 746
The QFX Series has a console port with an RJ-45 connector. Use the console port to
connect the device to a management console or to a console server.
Ensure that you have an RJ-45 to DB-9 rollover cable available. An RJ-45 cable with an
RJ-45 to DB-9 adapter is provided with the device.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to the QFX Series, use a
combination of the RJ-45 cable and RJ-45 to DB-9 adapter supplied with the
device and a USB to DB-9 male adapter. You must provide the USB to DB-9
male adapter.
To connect the QFX Series to a management console (see
Figure 152 on page 387):
Connect one end of the Ethernet cable to the console port (labeled
1.
Connect the other end of the Ethernet cable into the console server (see
2.
Figure 151 on page 387) or management console (see
LEDs on the power supply are lit green and are on steadily.
command.
show chassis firmware
Copyright © 2018, Juniper Networks, Inc.
Figure 151 on page 387 and
).
CON
Figure 152 on page 387).