Figure 174: Attach 1 U Switch To Rack; Figure 175: Slide Mounting Rail Onto The Qfx5100-96S Rear Mounting Blade; Figure 176: Slide Mounting Blade Into 1 U Mounting Rail - Juniper QFabric QFX3000-G Hardware Documentation

Copyright © 2018, Juniper Networks, Inc.

Figure 174: Attach 1 U Switch to Rack

Figure 175: Slide Mounting Rail onto the QFX5100-96S Rear Mounting Blade

Continue to support the switch while sliding the rear mounting-blades into the channel
8.
of the side mounting-rails and securing the blades to the rack. Use the four mounting
screws (and cage nuts and washers if your rack requires them) to attach each blade
to the rack. (Use eight front-mounting screws for the QFX5100-96S.) Tighten the
screws. See Figure 176 on page

Figure 176: Slide Mounting Blade into 1 U Mounting Rail

Ensure that the switch chassis is level by verifying that all the screws on the front of
9.
the rack are aligned with the screws at the back of the rack.
Chapter 31: Installing a QFX5100 Node Device
439.
439