Figure 243: Installing A Wiring Tray In A Qfx3008-I Interconnect Device - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

Documentation

Removing a Bottom Fan Tray and Front Panel Display from a QFX3008-I Interconnect

Figure 243: Installing a Wiring Tray in a QFX3008-I Interconnect Device

Wiring Tray in a QFX3008-I Interconnect Device on page 58

Removing a Wiring Tray from a QFX3008-I Interconnect Device on page 608

A QFX3008-I Interconnect device bottom fan tray and front panel display is

field-replaceable and is hot-removable and hot-insertable; you can remove and replace

the fan tray while the device is running without turning off power to the device or disrupting

device functions. The rest of this topic uses bottom fan tray to mean bottom fan tray

and front panel display.

Do not remove a fan tray unless you have a replacement fan tray

The bottom fan tray installs horizontally as part of the panel display located directly

below the front card cage. A handle on the panel display faceplate facilitates handling

of the fan tray. There is a captive screw at the top of the panel display to secure the fan

tray in the chassis.

Chapter 41: Replacing QFX3008-I Components

Table of Contents