Juniper QFabric QFX3000-G Hardware Documentation page 655

Related
Documentation
Removing an AC Power Supply from a QFX3008-I Interconnect Device
Copyright © 2018, Juniper Networks, Inc.
follow the instructions in "Removing a 16-Port QSFP+ Front Card from a QFX3008-I
Interconnect Device" on page
To install a rear card in a QFX3008-I Interconnect device, follow the instructions in
"Installing a Rear Card in a QFX3008-I Interconnect Device" on page
rear card from a QFX3008-I Interconnect device, follow the instructions in
Rear Card from a QFX3008-I Interconnect Device" on page
To install a transceiver in a QFX3008-I Interconnect device, follow the instructions in
"Installing a Transceiver in a QFX Series Device" on page
from a QFX3008-I Interconnect device, follow the instructions in
from a QFX Series Device" on page
To install a power supply in a QFX3008-I Interconnect device, follow the instructions in
"Installing an AC Power Supply in a QFX3008-I Interconnect Device" on page
remove a power supply from a QFX3008-I Interconnect device, follow the instructions
in "Removing an AC Power Supply from a QFX3008-I Interconnect Device" on page
To install a wiring tray in a QFX3008-I Interconnect device, follow the instructions in
"Installing a Wiring Tray in a QFX3008-I Interconnect Device" on page
wiring tray from a QFX3008-I Interconnect device, follow the instructions in
a Wiring Tray from a QFX3008-I Interconnect Device" on page
QFX3008-I Interconnect Device Overview on page 37
The AC power supply in a QFX3008-I Interconnect device is a hot-insertable and
hot-removable field-replaceable unit (FRU). Six AC power supplies are installed in the
chassis. All power supplies install in the rear of the chassis in the slots provided at the
bottom. See "Slot Numbering for a QFX3008-I Interconnect Device" on page
Before you remove an AC power supply from the device, ensure that you understand how
to prevent ESD damage. See
Ensure that you have the following parts and tools available to remove an AC power
supply from a QFX3008-I Interconnect device:
Electrostatic discharge (ESD) grounding strap
Phillips (+) screwdriver, number 1
Replacement power supply
CAUTION: Do not leave the power supply slot empty while the device is
operational. Replace the power supply promptly.
To remove an AC power supply from a QFX3008-I Interconnect device (see
Figure 240 on page 606):
Chapter 41: Replacing QFX3008-I Components
634.
707.
"Prevention of Electrostatic Discharge Damage" on page
641. To remove a
"Removing a
640.
709. To remove a transceiver
"Removing a Transceiver
607. To
610. To remove a
"Removing
608.
44.
605.
360.
605