Juniper QFabric QFX3000-G Hardware Documentation page 942

QFX3000-G QFabric System Hardware Documentation
Packing EX4300 Switch Components for Shipping
892
To pack the switch:
If the switch is installed in a rack or cabinet, have one person support the weight of
1.
the switch while another person unscrews and removes the mounting screws.
Remove the switch from the rack or cabinet and place the switch on a flat, stable
2.
surface.
Use the screwdriver to remove the rack-mounting brackets from the switch chassis.
3.
Place the switch in an antistatic bag.
4.
Place the bottom portion of the packaging foam in the shipping carton.
5.
Place the switch inside the cavity in the bottom packaging foam.
6.
Place the top portion of the packaging foam on top of the switch.
7.
If you are returning accessories or field-replaceable units (FRUs) with the switch, pack
8.
them as instructed in "Packing EX4300 Switch Components for Shipping" on page
Place the accessory box vertically by the rear end of the chassis in the shipping carton.
9.
Close the top of the cardboard shipping box and seal it with packing tape.
10.
Write the RMA number on the exterior of the box to ensure proper tracking.
11.
To pack the switch components, follow the instructions here.
Ensure that you have the following parts and tools available:
Antistatic bag, one for each component
ESD grounding strap
CAUTION: Do not stack switch components. Return individual components
in separate boxes if they do not fit together on one level in the shipping box.
To pack the switch components:
Place individual components in antistatic bags.
Use the original packing materials if they are available. If the original packing materials
are not available, ensure the component is adequately packed to prevent damage
Copyright © 2018, Juniper Networks, Inc.
892.