Figure 301: Removing A Power Supply From The Switch - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
696
Remove the power source cable from the power supply faceplate:
3.
AC power supply—Gently pull out the female end of the power cord connected to
the power supply faceplate.
DC power supply—Remove the screws securing the ring lugs attached to the power
source cables to the power supply using the screwdriver, and remove the power
source cables from the power supply. Replace the screws on the terminals and
tighten them.
Loosen the locking lever screw on the left front of the power supply by using the
4.
screwdriver.
Push down on the locking lever until it is in its lowest position.
5.
Grasp the power supply handle and pull firmly to slide it halfway out of the chassis.
6.
Place one hand under the power supply to support it and slide it completely out of
7.
the chassis. Take care not to touch power supply components, pins, leads, or solder
connections.
Place the power supply in the antistatic bag or on the antistatic mat placed on a flat,
8.
stable surface.

Figure 301: Removing a Power Supply from the Switch

Installing a Power Supply in an EX4200 Switch on page 697
Installing and Removing EX4200 Switch Hardware Components
Power Supply in EX4200 Switches on page 188
Field-Replaceable Units in EX4200 Switches on page 185
AC Power Cord Specifications for EX4200 Switches on page 312
Rear Panel of an EX4200 Switch
Copyright © 2018, Juniper Networks, Inc.