Figure 223: Connecting A Fiber-Optic Cable To An Optical Transceiver Installed; In An Ex Series Switch; Table 148: Virtual Chassis-To-Virtual Chassis Fiber-Based Control Plane Port; Table 149: Virtual Chassis-To-Virtual Chassis Fiber-Based Control Plane Port - Juniper QFabric QFX3000-G Hardware Documentation

Table 148: Virtual Chassis-to-Virtual Chassis Fiber-Based Control Plane Port Assignments for EX 4200
Member 0 Member 1
on on
xe-0/1/0 xe-1/1/0
EX0 to EX0 to
on on
xe-0/1/0 xe-1/1/0
EX1 EX1
Table 149: Virtual Chassis-to-Virtual Chassis Fiber-Based Control Plane Port Assignments for EX4300
Member 0
on EX0 to
xe-0/1/0 xe-0/1/0
on EX1
Copyright © 2018, Juniper Networks, Inc.
Chapter 36: Cabling a Fiber-Based Control Plane for the QFX3000-G QFabric System
system. It also permits the use of a standard Virtual Chassis configuration (see Example:
Configuring a Fiber-Based Control Plane for the QFX3000-G QFabric System.
Member 2 Member 3
on on
xe-2/1/0 xe-3/1/0
EX0 to EX0 to
on on
xe-2/1/0 xe-3/1/0
EX1 EX1
Member 1
on EX0 to
xe-1/1/0 xe-1/1/0
on EX1
To interconnect two Virtual Chassis for QFabric system control plane redundancy (see
Figure 222 on page 520):
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to transceivers emit laser light that can damage your eyes.
If the fiber-optic cable connector is covered by a rubber safety cap, remove the cap.
1.
Save the cap.
Remove the rubber safety cap from the SFP+ optical transceiver in port
2.
of the first Virtual Chassis. Save the cap.
Insert the cable connector into the optical transceiver (see
3.
Figure 223: Connecting a Fiber-Optic Cable to an Optical Transceiver Installed in an EX
Series Switch
If the connector at the other end of the fiber-optic cable is covered by a rubber safety
4.
cap, remove the cap. Save the cap.
Member 4 Member 5
on
xe-4/1/0 xe-5/1/0
EX0 to EX0 to
on
xe-4/1/0 xe-5/1/0
EX1 EX1
Member 2
on EX0 to
xe-2/1/0 xe-2/1/0
on EX1
Transceiver
Fiber-optic cable
Member 6 Member 7
on on
xe-6/1/0 xe-7/1/0
EX0 to EX0 to
on on
xe-6/1/0 xe-7/1/0
EX1 EX1
Member 3
on EX0 to
xe-3/1/0 xe-3/1/0
on EX1
on member
0
Figure 213 on page
on
on
0
499).
521