Juniper QFabric QFX3000-G Hardware Documentation page 622

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

QFX3000-G QFabric System Hardware Documentation

Interconnect device

Fabric manager

Fabric control

Diagnostic routing engine

Director group

0281112011000023

0281112011000082

The Interconnect device must show as

orderly shutdown.

Start the orderly shutdown of the QFX3008-I Interconnect device by issuing the

request fabric power-off interconnect-device serial-id | alias-name

command from the QFabric default partition CLI. This command systematically takes

the interconnect offline and gracefully shuts down the device while preserving system

state information. A message appears on the console or console log, confirming that

the operating system has stopped on the device.

You see output similar to the following after entering the command:

user@qfabric> show fabric administration inventory

Ungrouped Node device

in order to have an

operational mode

Configuration

Disconnected

Chapters

Table of Contents