Juniper QFabric QFX3000-G Hardware Documentation page 542

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
Installing and Connecting an EX4300 Switch
492
Follow instructions for connecting power as appropriate for your site:
6.
Connecting AC Power to an EX4200 Switch
Connecting DC Power to an EX4200 Switch
Perform initial configuration of the switch by following instructions in Connecting and
7.
Configuring an EX Series Switch (CLI Procedure) or Connecting and Configuring an EX
Series Switch (J-Web Procedure).
Set the switch's management options by following the appropriate instructions:
8.
Connecting a Device to a Network for Out-of-Band Management
Connecting a Device to a Management Console by Using an RJ-45 Connector
Rack Requirements
Cabinet Requirements
Clearance Requirements for Airflow and Hardware Maintenance for EX4200 Switches
on page 254
To install and connect an EX4300 switch:
Follow instructions in Unpacking an EX4300 Switch.
1.
Install a power supply if it is not preinstalled:
2.
Installing an AC Power Supply in an EX4300 Switch on page 683
Installing a DC Power Supply in an EX4300 Switch
Install a fan module if it is not preinstalled; see
3.
Switch" on page 691.
Mount the switch by following instructions appropriate for your site:
4.
Mounting an EX4300 Switch on Two Posts of a Rack or Cabinet (by using the mounting
brackets provided)
Mounting an EX4300 Switch in a Recessed Position in a Rack or Cabinet (by using
the 2-in.-recess front brackets from the separately orderable four-post rack-mount
kit)
Mounting an EX4300 Switch on Four Posts of a Rack or Cabinet (by using the
separately orderable four-post rack-mount kit)
Mounting an EX4300 Switch on a Wall (by using the separately orderable wall-mount
kit)
Follow instructions in "Connecting Earth Ground to an EX Series Switch" on page
5.
"Installing a Fan Module in an EX4300
Copyright © 2018, Juniper Networks, Inc.
175.