Installing The Control Plane Network - Juniper QFabric QFX3000-G Hardware Documentation

CHAPTER 34

Installing the Control Plane Network

Installing and Connecting an EX4200 Switch
Copyright © 2018, Juniper Networks, Inc.
Installing and Connecting an EX4200 Switch on page 491
Installing and Connecting an EX4300 Switch on page 492
Cabling EX4200 or EX4300 Series Switches Virtual Chassis for a QFX3000-G QFabric
System Control Plane on page 493
The EX4200 switch chassis is a rigid sheet-metal structure that houses the hardware
components.
To install and connect an EX4200 switch:
Follow instructions in Unpacking an EX4200 Switch.
1.
Install a power supply if it is not pre-installed; see
2.
EX4200 Switch" on page
Install a fan tray if it is not pre-installed; see
3.
on page 705.
Mount the switch by following instructions appropriate for your site:
4.
Mounting an EX4200 Switch on Two Posts in a Rack or Cabinet (using the mounting
brackets provided)
Mounting an EX4200 Switch on Four Posts in a Rack or Cabinet (using the separately
orderable four-post rack-mount kit)
Mounting an EX4200 Switch in a Recessed Position in a Rack or Cabinet (using the
2-in.-recess front brackets from the separately orderable four-post rack-mount kit)
Mounting an EX4200 Switch on a Desk or Other Level Surface (using the rubber feet
provided)
Mounting an EX4200 Switch on a Wall (using the separately orderable wall-mount
kit)
Follow instructions in "Connecting Earth Ground to an EX Series Switch" on page
5.
"Installing a Power Supply in an
697.
"Installing a Fan Tray in an EX4200 Switch"
175.
491