Figure 200: Slide Mounting Rail Onto The Rear Mounting Blade - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

Documentation

Figure 200: Slide Mounting Rail onto the Rear Mounting Blade

Align the holes in the mounting brackets with the holes in the rack. Ensure that the

chassis is level.

With four front mounting screws–and cage nuts and washers if your rack requires

them–attach the mounting bracket to the rack. Insert the first screw on the opposite

corner from the mounting blade. Tighten the screws.

Ensure that the switch chassis is level by verifying that the screws on the front of the

rack are aligned with the screws at the back of the rack.

With two mounting screws—and cage nuts and washers if your rack requires

them—slide the second rear mounting blade into the blade receptacle on the mounting

blade, and secure it to the rear of the rack by tightening the screws. You might need

to loosen and adjust the other mounting blade to install the second blade.

Rack-Mounting and Cabinet-Mounting Warnings on page 343

Connecting AC Power to a QFX3500, QFX3600, or QFX3600-I Device on page 463

Configuring a QFX3500 Device as a Standalone Switch

Chapter 33: Installing a QFX3500 Node Device

Table of Contents