Juniper QFabric QFX3000-G Hardware Documentation page 467

Copyright © 2018, Juniper Networks, Inc.
NOTE: Each wiring tray must be connected to a dedicated AC power source
outlet.
Before you begin to prepare the wiring trays for installation:
Ensure that you understand how to prevent ESD damage. See
Electrostatic Discharge Damage" on page
Ensure that you have the following parts and tools available to prepare the wiring trays
for installation:
Electrostatic discharge (ESD) grounding strap
Phillips (+) screwdriver, number 2
Power cords appropriate for your wiring trays and geographical location. See
Cord Specifications for a QFX3008-I Interconnect Device with Three-Phase Delta
Wiring Trays" on page 285
Interconnect Device with Three-Phase Wye Wiring Trays" on page
WARNING: Ensure that the power cords do not block access to device
components or drape where people can trip on them.
To prepare three-phase power cords for installation:
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the chassis.
Ensure that the power cords are not connected to power outlets. Switch off the
2.
customer site circuit breakers. Ensure that the voltage across the AC power source is
0 V and that there is no chance that the voltage might become active during
installation.
Remove a wiring tray from the chassis. See
3.
Interconnect Device" on page
Flip the breaker on the wiring tray faceplate to the OFF (O) position.
4.
Using a number 2 Phillips (+) screwdriver, loosen and remove the screws and washers
5.
that hold the square flat connector to the wiring tray. Keep the screws and washers.
Depending on how you want to dress the power cords, decide whether to use the 90°
6.
connector to attach the power cord to the wiring tray or the square flat connector
that you removed in Step 5.
Chapter 29: Installing a QFX3008-I Interconnect Device
360.
or "AC Power Cord Specifications for a QFX3008-I
"Removing a Wiring Tray from a QFX3008-I
608.
"Prevention of
"AC Power
286.
417