Juniper QFabric QFX3000-G Hardware Documentation page 649

Related
Documentation
0 1
Slot 1 2
Removing an HDD Module from a QFX3100 Director Device
Copyright © 2018, Juniper Networks, Inc.
Figure 237: Installing an HDD Module in a QFX3100 Director Device
Tighten captive screws.
0 1
Slot 1
2
Loosen captive screws.
Network Modules in a QFX3100 Director Device on page 32
Loosen captive screws.
Rear Panel of a QFX3100 Director Device on page 30
0 1
Slot 1
2
QFX3100 Director devices have two 2-terabyte (TB) hard disk drive (HDD) module slots
on the front panel. HDD modules are field-replaceable units (FRUs) and hot-swappable.
At least one HDD module should always be installed in a QFX3100 Director device and
the array volume should have the status of Optimal.
BEST PRACTICE:
Director device from the network before replacing the HDD to ensure the
integrity of the remaining Director device.
Before you begin removing an HDD module from a QFX3100 Director device:
Ensure that you understand how to prevent electrostatic discharge (ESD) damage.
See "Prevention of Electrostatic Discharge Damage" on page
Ensure that you have the following parts and tools available:
ESD grounding strap
Phillips (+) screwdriver, number 2
Antistatic bag or antistatic mat
Replacement HDD module for the HDD module slot
Chapter 40: Replacing QFX3100 Components
Athough the HDD is hot-swappable, isolate the QFX3100
Tighten captive screws.
0 1
Slot 1
2
Tighten captive screws.
0
1
Slot 1 2
0 1
Slot 1 2
360.
599
Ti
Ti