Juniper QFabric QFX3000-G Hardware Documentation page 307

CHAPTER 11
Port and Interface Specifications
USB Port Specifications for the QFX Series
Copyright © 2018, Juniper Networks, Inc.
USB Port Specifications for the QFX Series on page 257
USB Port Specifications for an EX Series Switch on page 258
Determining Transceiver Support for QFabric Systems on page 258
Console Port Connector Pinout Information on page 259
Management Port Connector Pinouts for the QFX Series on page 260
RJ-45 Management Port Connector Pinout Information on page 261
Management Port Connector Pinout Information for an EX4200 Switch on page 261
Network Module Port Connector Pinouts for a QFX3100 Director Device on page 262
The following Juniper Networks USB flash drives have been tested and are officially
supported for the USB port in the QFX Series:
RE-USB-1G-S—1-gigabyte (GB) USB flash drive (except QFX3100 Director device)
RE-USB-2G-S—2-GB USB flash drive (except QFX3100 Director device)
RE-USB-4G-S—4-GB USB flash drive
CAUTION: Any USB memory product not listed as supported for the QFX
Series has not been tested by Juniper Networks. The use of any unsupported
USB memory product could expose your device to unpredictable behavior.
Juniper Networks Technical Assistance Center (JTAC) can provide only limited
support for issues related to unsupported hardware. We strongly recommend
that you use only supported USB flash drives.
CAUTION: Remove the USB flash drive before upgrading Junos OS or
rebooting a QFX Series device. Failure to do so could expose your device to
unpredictable behavior.
257