Figure 242: Removing A Wiring Tray From A Qfx3008-I Interconnect Device - Juniper QFabric QFX3000-G Hardware Documentation

Copyright © 2018, Juniper Networks, Inc.
To remove a wiring tray from a QFX3008-I Interconnect device (see
Figure 242 on page 609):
Set the wiring tray power switch to the OFF (O) position.
1.
If the AC power source has a power switch, set it to the OFF (O) position, and unplug
2.
the power cord or cords from the AC power source.
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
3.
point on the chassis.
Unscrew the captive screw, located at the top of each wiring tray, counterclockwise
4.
using your fingers. If you cannot easily unscrew the captive screw with your fingers,
use the screwdriver.
Taking care not to touch wiring tray components, pins, leads, or solder connections,
5.
place one hand under the wiring tray to support it. Grasp the wiring tray handle with
your other hand, depress the tab at the top of the wiring tray, and pull the wiring tray
completely out of the chassis.

Figure 242: Removing a Wiring Tray from a QFX3008-I Interconnect Device

Loosen
thumbscrew
and depress
the tab.
Chapter 41: Replacing QFX3008-I Components
609