Juniper QFabric QFX3000-G Hardware Documentation page 588

QFX3000-G QFabric System Hardware Documentation
538
Install your QFabric system hardware (Director group, Interconnect devices, and Node
devices). For more information, see
Device" on page 377, "Installing and Connecting a QFX3008-I Interconnect Device" on
page 389, "Installing and Connecting a QFX3600 or QFX3600-I Device" on page
"Installing and Connecting a QFX3500 Device" on page
Install your Virtual Chassis hardware (EX4200 or EX4300 switches). For more
information, see "Installing and Connecting an EX4200 Switch" on page
and Connecting an EX4300 Switch" on page
Create two Virtual Chassis of eight EX4200-24F switch members or four EX4300-48P
switch members.
See "Cabling EX4200 or EX4300 Series Switches Virtual Chassis for a QFX3000-G
QFabric System Control Plane" on page
See Configuring an EX4200, EX4500, or EX4550 Virtual Chassis (CLI Procedure) or
Configuring an EX2300, EX3400, or EX4300 Virtual Chassis.
Interconnect the two Virtual Chassis switches using the 10-Gigabit Ethernet SFP+
uplink ports. See "Interconnecting Two Virtual Chassis for Copper-Based QFX3000-G
QFabric System Control Plane Redundancy" on page
Ensure that you have installed 1-Gigabit Ethernet SFP transceivers in management
ports and on each QFX3600 Node device (see
C0S C1S
QFX Series Device" on page
see The Hardware Compatibility Tool
Ensure that you have installed 1-Gigabit Ethernet SFP transceivers in the ports you are
using on each EX Series switch (see Installing a Transceiver). For a list of supported
transceivers, see
The Hardware Compatibility Tool
Ensure that you have appropriate fiber-optic cables.
Ensure that you have taken the necessary precautions for safe handling of lasers (see
"Laser and LED Safety Guidelines and Warnings for the QFX Series" on page
Use Table 155 on page 539
device-to-Virtual Chassis port mappings. Specific ports have been reserved on the
Virtual Chassis to connect to each of the QFX Series device types. Such design simplifies
installation and facilitates timely deployment of a QFabric system. It also permits the
use of a standard Virtual Chassis configuration (see Example: Configuring a Fiber-Based
Control Plane for the QFX3000-G QFabric System).
NOTE: The numerical identifiers for each Node device below are not
preassigned to the Node devices that are shipped to you. They represent
the order in which you connect the Node devices. For example, the first
Node device (Node 0) is connected to port
Chassis.
"Installing and Connecting a QFX3100 Director
492.
493.
709). For a list of supported transceivers and required cables,
.
.
or Table 156 on page 539 to determine the QFX3600 Node
Copyright © 2018, Juniper Networks, Inc.
453, and
473.
491or "Installing
497.
"Installing a Transceiver in a
350).
on each Virtual
ge-0/0/0