Juniper QFabric QFX3000-G Hardware Documentation page 620

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
Removing a QFX3100 Director Device from a Rack or Cabinet
570
Example: Configuring the Virtual Chassis for a Copper-Based QFX3000-G QFabric System
Control Plane
Example: Configuring EX Series Switches for the QFX3000-M QFabric System Control
Plane
Removing a QFX3100 Director Device from a Rack or Cabinet on page 570
If you need to relocate an installed QFX3100 Director device, use the procedure described
in this topic. (The remainder of this topic uses "rack" to mean "rack or cabinet.")
NOTE: When you remove multiple devices from a rack, remove the device in
the top of the rack first and proceed to remove the rest of the devices from
top to bottom.
Before removing a QFX3100 Director device from a rack:
Ensure that the rack is stable and secured to the building.
Ensure that there is enough space to place the removed QFX3100 Director device in
its new location and along the path to the new location.
Read "General Safety Guidelines and Warnings" on page
Ensure that the QFX3100 Director device has been safely powered off (see
Off a QFX3100 Director Device" on page
(disconnected) the power cords.
Ensure that you have disconnected any cables or wires attached to the QFX3100
Director device ports.
Ensure that you have the following parts and tools available:
A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your rack
mounting screws, for mounting the QFX3100 Director device on the rack.
To remove a QFX3100 Director device from a rack or cabinet:
Use the screwdriver to remove the mounting screws that attach the chassis
1.
front-mounting brackets to the rack or cabinet.
Place the removed screws in a labeled bag. You will need them when you reinstall
2.
the chassis.
Lift the QFX3100 Director device from the rack or cabinet and transport it to your
3.
desired new location.
329.
559) and that you have unplugged
Copyright © 2018, Juniper Networks, Inc.
"Powering