Figure 382: Location Of The Serial Number Id Label On An Ex4200 Switch - Juniper QFabric QFX3000-G Hardware Documentation

Locating the Chassis Serial Number ID Label on an EX4200 Switch
Locating the Serial Number ID Labels on FRUs in an EX4200 Switch
Related
Documentation
Packing a QFX3100 Director Device or Component for Shipping
Copyright © 2018, Juniper Networks, Inc.
PIC 0
PIC 1 REV 03B
Power Supply 0 REV 03
Fan Tray
For information about the
EX4200 switches have serial number ID labels located on the rear panel of the chassis
(see Figure 382 on page 881).

Figure 382: Location of the Serial Number ID Label on an EX4200 Switch

The power supplies, fan trays, and uplink modules installed in EX Series switches are
field-replaceable units (FRUs).
For each of these FRUs, you must remove the FRU from the switch chassis to see the
FRU's serial number ID label.
Power Supply—The serial number ID label is on the top of the power supply. See
"Removing a Power Supply from an EX4200 Switch" on page
Fan tray—The serial number ID label is on the back of the fan tray. See
Fan Tray in an EX4200 Switch" on page
Uplink module—The serial number ID label is on the circuit board. See
Uplink Module from an EX4200 Switch" on page
Contacting Customer Support to Obtain Return Material Authorization
Returning an EX4200 Switch or Component for Repair or Replacement on page 865
If you are returning a QFX3100 Director device or component to Juniper Networks for
repair or replacement, pack the item as described in this topic.
Before you begin packing QFX3100 Director device or component, ensure that you have:
Taken the necessary precautions to prevent ESD damage (see
Electrostatic Discharge Damage" on page
BUILTIN BUILTIN
711-021270 AR0208162285
740-020957 AT0508346354
command, see show chassis hardware.
show chassis hardware
705.
699.
360).
Chapter 58: Returning Hardware
24x 10/100/1000 Base-T
4x GE SFP
PS 320W AC
Fan Tray
695.
"Installing a
"Removing an
"Prevention of
881