Juniper QFabric QFX3000-G Hardware Documentation page 590

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
Connecting a QFX3500 Node Device to a Fiber-Based QFX3000-G QFabric System
Control Plane Network
540
Insert the cable connector into the optical transceiver.
3.
Connect the other end of that cable to the appropriate port on the first Virtual Chassis.
4.
See Table 155 on page
Remove the rubber safety cap from the SFP optical transceiver in the second SFP
5.
management port (labeled
Insert the cable connector into the optical transceiver.
6.
Connect the other end of that cable to the appropriate port on the second EX Series
7.
switch. This should be the same port number that you connected to in Step 4. For
example, if you connected the first cable to
connect the second cable to
Repeat this procedure for each QFX3600 Node device.
8.
Secure the cables so that they are not supporting their own weight. Place excess cable
9.
out of the way in a neatly coiled loop. Placing fasteners on a loop helps cables maintain
their shape.
CAUTION: Do not bend fiber-optic cables beyond their minimum bend
radius. An arc smaller than a few inches in diameter can damage the cables
and cause problems that are difficult to diagnose.
Do not let fiber-optic cables hang free from the connector. Do not allow
fastened loops of cables to dangle, which stresses the cables at the
fastening point.
Connecting a QFX3600-I Interconnect Device to a Fiber-Based QFX3000-M QFabric
System Control Plane Network
Connecting a QFX3600 Node Device to a QFX3600-I Interconnect Device
Connecting QFX3100 Director Devices to a Fiber-Based QFX3000-M QFabric System
Control Plane Network
Connecting QFX3100 Director Devices in a Director Group on page 500
A QFX3000-G QFabric system control plane and management network is formed by
connecting the QFX Series devices in your network to two Virtual Chassis composed of
EX Series switches. If you are creating a fiber-based control plane network, you use eight
539.
C1S ) on the Node device front panel. Save the cap.
ge-0/0/0
on the second Virtual Chassis.
ge-0/0/0
on the first Virtual Chassis, you
Copyright © 2018, Juniper Networks, Inc.