Table 54: Parts And Tools Required For Connecting An Ex Series Switch To Earth - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
Parts and Tools Required for Connecting an EX Series Switch to Earth Ground
Table 54: Parts and Tools Required for Connecting an EX Series Switch to Earth Ground
Earthing
Terminal Grounding Cable
Switch Location Requirements
EX2200 Rear panel 14 AWG (2 mm²),
of the minimum 90° C wire,
chassis or as permitted by the
local code
EX2300-C Rear panel 14 AWG (2 mm²),
of the minimum 90° C wire,
chassis or as permitted by the
local code
176
supply. Using a grounding cable with an incorrectly attached lug can damage
the switch.
Parts and Tools Required for Connecting an EX Series Switch to Earth
Ground on page 176
Special Instructions to Follow Before Connecting Earth Ground to a Switch on page 180
Connecting Earth Ground to an EX Series Switch on page 182
Table 54 on page 176 lists the earthing terminal location, grounding cable requirements,
grounding lug specifications, screws and washers required, and the screwdriver needed
for connecting a switch to earth ground. Before you begin connecting a switch to earth
ground, ensure you have the parts and tools required for your switch.
Grounding Lug
Specifications
Panduit
LCC10-14BWL or
equivalent—
not provided
Panduit
LCC10-14AW-L or
equivalent—
not provided
Screws and
Washers Screwdriver
Two 10-32 Phillips (+)
x .25 in. screws number 2
with #10
split-lock
washer—
not provided
Two #10 flat
washers—not
provided
Two Phillips (+)
10-32 x .25 in. number 2
screws with #10
split-lock
washer—
not provided
Two #10 flat
washers—not
provided
Copyright © 2018, Juniper Networks, Inc.
Additional
Information