Figure 240: Removing An Ac Power Supply From A Qfx3008-I Interconnect - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
606
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the chassis.
Unscrew the captive screw, located at the top of each power supply, counter-clockwise
2.
using your fingers. If you cannot easily unscrew the captive screw with your fingers,
use the screwdriver.
Pull the captive screw away from the faceplate of the power supply to release the
3.
latch.
Pull the handle away from the faceplate of the power supply until it is perpendicular
4.
to the faceplate.
Taking care not to touch power supply components, pins, leads, or solder connections,
5.
place one hand under the power supply to support it. Grasp the power supply handle
with your other hand and pull the power supply completely out of the chassis.
Figure 240: Removing an AC Power Supply from a QFX3008-I Interconnect Device
Loosen
thumbscrew
AC Power Supply in a QFX3008-I Interconnect Device on page 56
Installing an AC Power Supply in a QFX3008-I Interconnect Device on page 607
Copyright © 2018, Juniper Networks, Inc.