Table 164: Control Board Leds On A Qfx3008-I Interconnect Device; Table 165: Control Board Sfp+ Port Leds On A Qfx3008-I Interconnect - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation

Table 164: Control Board LEDs on a QFX3008-I Interconnect Device

LED Color
Power Unlit
Green
Amber
Status Green
Amber
Master Unlit
Green
Table 165: Control Board SFP+ Port LEDs on a QFX3008-I Interconnect Device
LED Color
Link/Activity Unlit
Green
Status Unlit
Green
730
State
Off
On steadily
Blinking
On steadily
Intermittent blinking
On steadily
Blinking
Off
On steadily
Table 165 on page 730 describes the SFP+ port LEDs.
State
Off
On steadily
Flickering
Off
On steadily
Description
There is no power to the Control Board, or
the Control Board is not fully seated in the
chassis. See "Installing a Control Board in
a QFX3008-I Interconnect Device" on
page 631.
Control Board is powered on.
Control Board is offline.
Control Board is operating normally.
The beacon feature has been enabled on
the card using the
request chassis beacon
command.
Software is loading on the Control Board.
Control Board has failed to boot properly
and needs to be reset or reinstalled. See
"Installing a Control Board in a QFX3008-I
Interconnect Device" on page
Control Board is acting as the backup
Control Board.
Control Board is acting as the master
Control Board.
Description
No link is established, there is a fault, or
the link is down.
A link is established, but there is no link
activity.
A link is established, and there is link
activity.
No transceiver is installed in the port, the
port is configured for a different interface,
or the transceiver is not supported.
A transceiver is installed in the port.
Copyright © 2018, Juniper Networks, Inc.
631.