Juniper QFabric QFX3000-G Hardware Documentation page 704

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
Removing a Management Board from a QFX3500 Device
654
Management Board for a QFX3500 Device on page 128
Field-Replaceable Units in a QFX3500 Device on page 119
Connecting a QFX Series Device to a Management Console on page 386
Connecting a QFX3500 Node Device to a Copper-Based QFX3000-G QFabric System
Control Plane Network on page 515
Connecting a QFX3500 Device to a Network for Out-of-Band Management
Removing a Management Board from a QFX3500 Device on page 654
QFX3500 devices have a single field-replaceable unit (FRU) management board on the
front panel.
CAUTION: You must power off the QFX3500 device before replacing the
management board. If the QFX3500 is operating as a Node device in a QFabric
system, ensure that traffic is diverted in an orderly shutdown by using the
shutdown procedure in
Group" on page
Before you remove a management board from a QFX3500 device, ensure that you have
taken the necessary precautions to prevent electrostatic discharge (ESD) damage (see
"Prevention of Electrostatic Discharge Damage" on page
Ensure that you have the following parts and tools available to remove a management
board from a QFX3500 device:
ESD grounding strap
Antistatic bag or an antistatic mat
To remove a management board from a QFX3500 device (see
Place the antistatic bag or the antistatic mat on a flat, stable surface.
1.
Ensure that the QFX3500 device is powered off. See Powering Off a QFX3500 Device
2.
or "Adding or Replacing a Node Device in a QFabric Node Group" on page 578
systems.
Attach the ESD grounding strap to your bare wrist and to a site ESD point.
3.
Slide the locking lever toward the handle until it stops.
4.
"Adding or Replacing a Node Device in a QFabric Node
578.
360).
Figure 267 on page
in QFabric
Copyright © 2018, Juniper Networks, Inc.
655):