Juniper QFabric QFX3000-G Hardware Documentation page 424

QFX3000-G QFabric System Hardware Documentation
374
To install a QFX3000-G QFabric system:
Install all the devices in their permanent location, connect the devices to earth ground,
1.
and connect power to the devices. See:
Installing and Connecting a QFX3100 Director Device on page 377
Installing and Connecting a QFX3008-I Interconnect Device on page 389
Installing and Connecting a QFX5100 Device on page 433
Installing and Connecting a QFX3600 or QFX3600-I Device on page 453
Installing and Connecting a QFX3500 Device on page 473
Installing and Connecting an EX4200 Switch on page 491
Ensure that each Node device is set to Node device mode. By default, the devices
2.
work as standalone switches. You perform this step using the console (
each Node device. Leave the Node devices powered on. See Converting the Device
Mode for a QFabric System Component.
Cable two Virtual Chassis of four EX4200 switches each. See Understanding Virtual
3.
Chassis Hardware Configuration on an EX4200 Switch and Virtual Chassis Cabling
Configuration Examples for EX4200 Switches.
Interconnect the two Virtual Chassis using the 10-Gigabit Ethernet SFP+ uplink ports.
4.
These ports will later be configured in a LAG. See
for Copper-Based QFX3000-G QFabric System Control Plane Redundancy" on page
Interconnect the two QFX3100 Director devices for control plane redundancy. See
5.
"Connecting QFX3100 Director Devices in a Director Group" on page
Connect each QFX Series device to each Virtual Chassis for control plane
6.
interconnection. See:
Connecting QFX3100 Director Devices to a Copper-Based QFX3000-G QFabric
System Control Plane Network on page 502
Connecting a QFX3008-I Interconnect Device to a Copper-Based QFX3000-G
QFabric System Control Plane Network on page 505
Connecting a QFX5100 Node Device to a Copper-Based QFX3000-G QFabric
System Control Plane Network on page 510
Connecting a QFX3600 Node Device to a Copper-Based QFX3000-G QFabric
System Control Plane Network on page 512
Connecting a QFX3500 Node Device to a Copper-Based QFX3000-G QFabric
System Control Plane Network on page 515
Connect each Node device to each QFX3008-I Interconnect Device for data plane
7.
interconnection. See:
Connecting a QFX3500 Node Device to a QFX3008-I Interconnect Device on page 548
CON
"Interconnecting Two Virtual Chassis
500.
Copyright © 2018, Juniper Networks, Inc.
) port on
497.