Figure 302: Installing A Power Supply In An Ex4200 Switch - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
698

Figure 302: Installing a Power Supply in an EX4200 Switch

NOTE: Each power supply must be connected to a dedicated power source
outlet.
NOTE: EX4200-24PX and EX4200-48PX switches do not support the 930
W (
EX-PWR-930-AC
that are used in the EX4200-48P and the EX4200-24P switch models.
EX4200-24PX and EX4200-48PX switches work only with the power supply
labeled
EX-PWR2-930-AC
supply (see "Removing a Power Supply from an EX4200 Switch" on page
The
EX-PWR2-930-AC
line.
NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
Removing a Power Supply from an EX4200 Switch on page 695
Installing and Removing EX4200 Switch Hardware Components
Power Supply in EX4200 Switches on page 188
Field-Replaceable Units in EX4200 Switches on page 185
AC Power Cord Specifications for EX4200 Switches on page 312
Rear Panel of an EX4200 Switch
Troubleshooting Power Supply Installation Alarms on EX4200 Switches
) or the 600 W (
EX-PWR-600-AC
. You can find the label on the top of the power
power supply is supported across the EX4200 product
Copyright © 2018, Juniper Networks, Inc.
) AC power supplies
695).
. Failure