Juniper QFabric QFX3000-G Hardware Documentation page 944

QFX3000-G QFabric System Hardware Documentation
Packing EX4200 Switch Components for Shipping
Related
Documentation
894
Remove the cables that connect the switch to all external devices. See Disconnecting
3.
a Fiber-Optic Cable.
Remove all field-replaceable units (FRUs) from the switch.
4.
If the switch is installed on a wall, rack, or cabinet, have one person support the weight
5.
of the switch while another person unscrews and removes the mounting screws.
Remove the switch from the wall, rack, cabinet, or desk and place the switch in an
6.
antistatic bag.
Place the switch in the shipping carton.
7.
Place the packing foam on top of and around the switch.
8.
If you are returning accessories or FRUs with the switch, pack them as instructed in
9.
the following section.
Replace the accessory box on top of the packing foam.
10.
Close the top of the cardboard shipping box and seal it with packing tape.
11.
Write the RMA number on the exterior of the box to ensure proper tracking.
12.
CAUTION: Do not stack switch components. Return individual components
in separate boxes if they do not fit together on one level in the shipping box.
To pack and ship switch components:
Place individual boards in antistatic bags.
Ensure that the components are adequately protected with packing materials and
packed so that the pieces are prevented from moving around inside the carton.
Close the top of the cardboard shipping box and seal it with packing tape.
Write the RMA number on the exterior of the box to ensure proper tracking.
Returning an EX4200 Switch or Component for Repair or Replacement on page 865
Installing a Fan Tray in an EX4200 Switch on page 705
Removing a Power Supply from an EX4200 Switch on page 695
Removing an Uplink Module from an EX4200 Switch on page 699
Copyright © 2018, Juniper Networks, Inc.