Figure 320: Rear Card Leds On A Qfx3008-I Interconnect Device; Table 168: Rear Card Leds On A Qfx3008-I Interconnect Device - Juniper QFabric QFX3000-G Hardware Documentation

Rear Card LEDs on a QFX3008-I Interconnect Device

Table 168: Rear Card LEDs on a QFX3008-I Interconnect Device

LED Color
Status Green
Amber
Power Unlit
Green
Amber
Copyright © 2018, Juniper Networks, Inc.
Taking a 16-Port QSFP+ Front Card Offline in a QFX3008-I Interconnect Device on
page 633
Removing a 16-Port QSFP+ Front Card from a QFX3008-I Interconnect Device on
page 634
Each rear card has two LEDs on the right side of the module front panel that indicate rear
card status. See Figure 320 on page

Figure 320: Rear Card LEDs on a QFX3008-I Interconnect Device

Ejector levers
Table 168 on page 733 describes these LEDs, their colors and states, and the status they
indicate.
State
On steadily
Intermittent blinking
On steadily
Blinking
Off
On steadily
Blinking
Chapter 50: Viewing QFX3008-I System Information
733.
Description
Rear card is operating normally.
The beacon feature has been enabled on
the card using the
command.
Software is loading on the rear card.
Rear card has failed and needs to be
replaced. See
Front Card in a QFX3008-I Interconnect
Device" on page
There is no power to the rear card, or the
rear card is not fully seated in the chassis.
See "Installing a Rear Card in a QFX3008-I
Interconnect Device" on page
Rear card is powered on.
Rear card is offline.
Rear card status LEDs
request chassis beacon
"Installing a 16-Port QSFP+
636.
641.
733