Table 140: Inventory Of Components Supplied With A Qfx3500 Device - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
Unpacking a QFX3500 Device

Table 140: Inventory of Components Supplied with a QFX3500 Device

Component
Chassis with management board, two fan trays, and one or two power supplies
474
Rack Requirements for a QFX3500 Device on page 235
Cabinet Requirements for a QFX3500 Device on page 242
Clearance Requirements for Airflow and Hardware Maintenance for a QFX3500 Device
on page 250
The QFX3500 device chassis is a rigid sheet-metal structure that houses the hardware
components. A QFX3500 device is shipped in a cardboard carton, secured with foam
packing material. The carton also contains an accessory box and quick start instructions.
CAUTION: QFX3500 devices are maximally protected inside the shipping
carton. Do not unpack the device until you are ready to begin installation.
To unpack a QFX3500 device:
Move the shipping carton to a staging area as close to the installation site as possible,
1.
but where you have enough room to remove the system components.
Position the carton so that the arrows are pointing up.
2.
Open the top flaps on the shipping carton.
3.
Remove the accessory box and verify the contents against the inventory included in
4.
the box. Table 140 on page 474
QFX3500 device.
Pull out the packing material holding the device in place.
5.
Verify the chassis components received:
6.
Management board
Two fan trays
One or two power supplies, depending on your order. If only one power supply is
installed, a blank panel should be installed on the second power supply slot.
Save the shipping carton and packing materials in case you need to move or ship the
7.
device later.
lists the inventory of components supplied with a
Copyright © 2018, Juniper Networks, Inc.
Quantity
1