Juniper QFabric QFX3000-G Hardware Documentation page 819

Table 193: LCD Panel Menu Options in EX4300 Switches (continued)
Menu Label Description
MAINT The Maintenance menu has the following options to configure and troubleshoot the switch:
(Maintenance
SYSTEM HALT?—Choose one of the following:
Menu)
Press Enter to halt the switch. Press Enter again to confirm the halt.
Press Menu to go to the next option in the Maintenance menu.
SYSTEM REBOOT?—Choose one of the following:
Press Enter to reboot the switch. Press Enter again to confirm the reboot.
Press Menu to go to the next option in the Maintenance menu.
LOAD RESCUE?—Choose one of the following:
Press Enter to roll back the switch to the previous valid configuration. Press Enter again to confirm the
rollback.
Press Menu to go to the next option in the Maintenance menu.
REQUEST VC PORT?—Choose one of the following:
Press the Enter button to configure an uplink module port or a built-in QSFP+ port to be a VCP or to
delete a VCP from the switch configuration (when you delete the VCP, the port is reset to be an uplink
module port or a network port).
Press the Menu button to go to the next option in the Maintenance menu.
FACTORY DEFAULT?—Choose one of the following:
Press Enter to restore the switch to the factory default configuration. Press Enter again to confirm the
restoration. The LCD panel flashes a success or failure message, after which it displays the Idle menu.
Press Menu to go to the next option in the Maintenance menu.
ENTER EZSETUP?—Choose one of the following:
Press Enter to launch EZSetup. Press Enter again to confirm the launch.
EZSetup configures DHCP and enables the J-Web user interface on the switch. The LCD panel flashes
a success or failure message for approximately 10 seconds, after which it displays the Idle menu.
NOTE:
For information about EZSetup, see Connecting and Configuring an EX Series Switch (J-Web Procedure).
Press Menu to go to the next option in the Maintenance menu.
EXIT MAINT MENU?—Choose one of the following:
Press Enter to exit the Maintenance menu.
Press Menu to return to the SYSTEM HALT? option.
You can disable the Maintenance menu or the options in the Maintenance menu in the LCD panel. See
Configuring the LCD Panel on EX Series Switches (CLI Procedure).
Related
Documentation
Chassis Status LEDs on EX4300 Switches
Copyright © 2018, Juniper Networks, Inc.
You can use EZSetup only on a standalone switch that is in the factory default configuration.
EX4300 Switches Hardware Overview on page 137
Connecting and Configuring an EX Series Switch (CLI Procedure)
EX4300 switches except EX4300-48MP and EX4300-48MP-S switches have three
chassis status LEDs (labeled
the Menu and Enter buttons (see
Chapter 54: Viewing EX4300 System Information
, , and ) on the right of the LCD panel, next to
ALM SYS MST
Figure 343 on page 770). EX4300-48MP and
769