Figure 41: Qfx5100-24Q-Aa Port Panel With Qfx-Pfa-4Q; Figure 42: Qfx-Pfa-4Q Expansion Module - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:
Table of Contents

Advertisement

QFX3000-G QFabric System Hardware Documentation
70

Figure 41: QFX5100-24Q-AA Port Panel with QFX-PFA-4Q

The QFX5100-24Q-AA can be used as a standalone switch that supports high frequency
statistics collection. Working with Juniper Networks Cloud Analytics Engine, this switch
monitors and reports the workload and application behavior across the physical and
virtual infrastructure.
The QFX5100-24Q-AA supports the following expansion modules to increase port
density:
QFX-PFA-4Q (double-wide), which provides four additional QSFP+ ports. See
Figure 42 on page
70.

Figure 42: QFX-PFA-4Q Expansion Module

QFX-EM-4Q (single-wide), which provides 4 additional 40-Gigabit Ethernet QSFP+
ports. See
Figure 39 on page
EX4600-EM-8F (single-wide), which provides 8 additional 10-Gigabit Ethernet SFP+
ports. See
Figure 40 on page
The QFX5100-24Q switch supports the QFX-PFA-4Q and you must take the switch
offline before replacing the expansion module. Any combination of EX4600-EM-8F
and QFX-EM-4Q is also supported. These two expansion modules can be hot-inserted
or hot-removed. However, when an EX4600-EM-8F is inserted instead of a QFX-EM-4Q,
the new configuration causes the interfaces to temporarily go down. Likewise, when
an EX4600-EM-8F is running on the QFX5100-24Q and is swapped with a QFX-EM-4Q,
the interfaces temporarily go down, which can cause a short disruption in traffic.
QFX5100-96S
As shown in
Figure 43 on page
Enhanced Small Form-Factor Pluggable (SFP+) top-of-rack switch with 96 SFP+
ports and 8 Quad SFP+ (QSFP+) ports. Each SFP+ port can operate as a native
10 Gigabit port, when 10 Gbps optics are used. The SFP+ ports can also run at 1 Gbps,
or at 100 Mbps speeds when 1_Gigabit optics are inserted. QSFP+ ports 96 and 100
can operate at native 40 Gbps speed or can be channelized to 4 independent 10 Gbps
port speeds. The 8 QSFP+ ports can be used as either access ports or as uplinks. The
68.
69.
71, the QFX5100-96S switch is a is a 10-Gigabit Ethernet
Copyright © 2018, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

Table of Contents