Figure 236: Removing A Network Module From A Qfx3100 Director Device - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

QFX3000-G QFabric System Hardware Documentation

Documentation

Installing a Network Module in a QFX3100 Director Device

Before you Power Off the Director Device

Figure 236: Removing a Network Module from a QFX3100 Director Device

Loosen captive screws.

Installing a Network Module in a QFX3100 Director Device on page 596

Network Modules in a QFX3100 Director Device on page 32

QFX3100 Director devices support up to two network modules on the front panel. The

network modules are field-replaceable units (FRUs) but may not be hot-swapped. You

must power off the system and configure the system for the new module before installing

a new network module. If you are replacing an existing network module and have already

edited the configuration files, you may proceed to

Director Device" on page

Before you Power Off the Director Device on page 596

Installing a Network Module in a Director Device on page 597

If you power off the QFX3100 Director device before configuring the new interfaces, the

new interfaces will stay down or be removed from the control plane when the Director

device is brought back up. If you are removing network module 1, you need to edit:

If you are removing network module 2, you need to edit:

"Installing a Network Module in a

Table of Contents